Qmax cutters
Qmax cutters
Anybody have one I could borrow to cut a hole or 2 for elements?
Regards Nic
http://forum.craftbrewing.org.uk/
http://forum.craftbrewing.org.uk/
- EckersKlein
- Posts: 122
- Joined: Thu Sep 27, 2012 11:42 pm
Re: Qmax cutters
I have a holesaw set, if that is an acceptable substitute. PM me if you want to borrow it, as I probably won't remember to check the forum tonight.
-Eric
-Eric
Re: Qmax cutters
Thanks for the offer, but its a stainless steel stock pot so I think it would trash a holesaw.
Regards Nic
http://forum.craftbrewing.org.uk/
http://forum.craftbrewing.org.uk/
- rodneygullick
- Posts: 289
- Joined: Mon Jun 13, 2011 2:24 pm
Re: Qmax cutters
there is a company in Brislington that sells them
Re: Qmax cutters
Is there, great, what are they called?
Regards Nic
http://forum.craftbrewing.org.uk/
http://forum.craftbrewing.org.uk/
Re: Qmax cutters
Got a 20.4mm Qmax, which iirc is what you need for a 1/2bsp tank connector (which is what I use for my mash tun)
Re: Qmax cutters
If I could borrow it sometime that would be great, I'm hoping to make it to the next BBC meeting.
If I can exchange a 19kg cylinder I've been given (which is a bit rusty) I'm looking at going gas, so I won't need to do element holes but a tap will be a must.
If I can exchange a 19kg cylinder I've been given (which is a bit rusty) I'm looking at going gas, so I won't need to do element holes but a tap will be a must.
Regards Nic
http://forum.craftbrewing.org.uk/
http://forum.craftbrewing.org.uk/
Re: Qmax cutters
No worries, I'll bring it along